Mimics Alarm Beeps
The V2 receiver will beep at the same rate at which signals are received by the transmitters (from the buzzer output), thereby sounding anything from a single bleep to a full-blown 'one-toner'.
Low Battery Warning
The receiver now has a low battery warning feature.
Improved Range and Performance
Under optimum bankside conditions, the new system has been tested up to 500m. This guarantees good signal range in the worst swims.
Multiple Tone Selection on the Receiver
V2 receiver comes with 10 different user selectable tones.
Activation on all LEDs
If you receive 2 or more simultaneous runs, the corresponding LEDs will be light up simultaneously.
Full ATT Warranty
The system is covered by a full ATT 2 year warranty.
Improved Transmitter Design
The transmitter has been re-designed to offer a smaller battery recess cover. The electronic circuitry is encased in it's own watertight compartment to prevent the risk of water ingress, transmitter corrosion and any resultant malfunction.
Compatibility with new products
The V2 system was built to be compatible with new ATT products currently under development. This may well include other manufacturers products.
Increased LED 'light Up' time
LEDs will remain on for 30 seconds after the last buzzer signal is received from the transmitter.
Last LED Activation Recall
Indicates the last LED that was lit up.
NOTE: The V1 & V2 systems cannot be used interchangeably, i.e. V1 transmitters will ONLY work with V1 receivers & vice versa.